Peugeot 2008 Oil Burning & Oil Consumption Prevention Kit (1.2 PureTech)

Which Motor Oil for the Peugeot 2008?

The 1.2 PureTech requires a fully synthetic oil. If your car consumes oil, 5W50 is recommended; if it does not, the OEM viscosity 5W30. Both are offered in this kit as Brava Extreme 9000 fully synthetic. The correct oil is also critical for the life of the wet belt.

Peugeot 2008 Oil Capacity

• Engine: 1.2 PureTech (110-130 hp)
• Oil capacity: ~3.5 L (~3.75 L with filter; may vary by engine code)
• Kit contents: 4 L Extreme 9000 + A980 NanoComplex 300 ml

Peugeot 2008 1.2 PureTech Oil Burning and Oil Consumption Problem

The 1.2 PureTech turbocharged petrol engine of the Peugeot 2008 — especially between 2014-2022, gen1 (2013-2019) and gen2 (2019-2022) — is known for oil consumption. While the upper limit accepted by Stellantis is 0.5 litres per 1,000 km, many 2008 owners report consumption of up to 1 litre per 1,000 km. The main causes are piston ring wear, fuel dilution of the oil and loss of oil pressure caused by the wet timing belt (belt-in-oil).

Oil Burning Prevention Kit for the Peugeot 2008

It tackles the problem from two sides: a fully synthetic oil in the right viscosity for the condition of the car + the A980 NanoComplex additive.

• 2008 that consumes oil → 4 L Brava Extreme 9000 5W50 + A980 NanoComplex — a thicker oil film that noticeably reduces consumption.
• No consumption / protection → 4 L Brava Extreme 9000 5W30 + A980 NanoComplex — preventive maintenance.

How Does A980 NanoComplex Reduce Oil Consumption?

A980 NanoComplex strengthens the oil film and reduces leakage around the piston rings, cuts oil passage into the combustion chamber and noticeably reduces consumption. It protects the engine against wear and lowers running noise.

Additive Recommendation for the Peugeot 2008

On the oil side, A980 NanoComplex against oil consumption (included in the kit). For fuel system / injector cleaning and combustion efficiency, a Brava S series fuel additive is recommended as a complement — clean combustion matters especially on PureTech engines that carry a fuel dilution risk.

Peugeot 2008 Oil Burning Symptoms

• Blue/grey smoke from the exhaust
• A frequent need to top up oil, oil level warning
• A clear level drop on long journeys
• Rough idle, an increase in engine noise

Not Driving a Peugeot 2008?

Ready-made kits for other models sharing the same 1.2 PureTech engine:

• Peugeot 208 Oil Burning Kit
• Peugeot 308 Oil Burning Kit
• Citroën C3 Oil Burning Kit
• Citroën C4 Oil Burning Kit
• All Oil Burning & Oil Consumption Kits

Frequently Asked Questions

At how many km does the Peugeot 2008 start burning oil?

On 2008 models with the 1.2 PureTech engine, consumption usually becomes noticeable after 60,000-100,000 km; on some cars it can appear earlier.

Which oil does the Peugeot 2008 1.2 PureTech use?

A fully synthetic oil; 5W50 if it consumes oil, otherwise 5W30. This kit contains Brava Extreme 9000 (5W50 or 5W30) + A980.

What is the oil capacity of the Peugeot 2008?

Approximately 3.5 litres (~3.75 with filter; varies by engine code); the kit contains 4 litres.

Is oil consumption normal on the Peugeot 2008?

The manufacturer's tolerance is up to 0.5 litres per 1,000 km; above that, the 5W50 + A980 kit is recommended and the condition of the wet belt should also be checked.

Will this kit stop oil burning on the Peugeot 2008?

A980 NanoComplex and the correct viscosity noticeably reduce oil consumption; unless there is severe mechanical damage (rings/belt), consumption comes close to normal on most cars.

Other Common Problems of the Peugeot 2008 1.2 PureTech

Besides oil consumption, the best-known chronic problem of the Peugeot 2008 1.2 PureTech engine is the wet timing belt (belt-in-oil). Its symptoms should not be ignored.

• Wet timing belt: The belt runs in oil; rubber particles breaking off the degraded surface fall into the sump and block the oil pick-up strainer. Symptoms: the red oil pressure light, a hard brake pedal (the vacuum pump is fed from the same oil circuit), a diesel-like noise and vibration. The belt must be replaced mechanically at an authorised service centre; however, the correct, clean oil extends its life by reducing the oil dilution that degrades the belt.
• Fuel dilution: Petrol mixes into the oil, the oil turns acidic and wears the belt. The correct fully synthetic oil + A980 NanoComplex and clean combustion reduce this effect.
• Turbo wear: At an advanced stage, increased oil consumption can wear the turbo; clean oil in the correct viscosity protects it.

Note: This kit targets the oil side of the Peugeot 2008 (consumption + protection); replacing the timing belt is a job for an authorised service centre.

Complete Maintenance and Additive Recommendation for the Peugeot 2008

• Oil consumption & protection: This kit — Brava Extreme 9000 (5W50/5W30) + A980 NanoComplex
• Clean combustion & reducing fuel dilution: Brava S50 Fuel Additive
• Injector cleaning: Brava A700 Injector System Cleaner
• Internal engine sludge / oil gallery cleaning: Brava A900 Engine Internal Cleaner

Peugeot 2008 Problems — Frequently Asked Questions

What are the timing belt symptoms on the Peugeot 2008?

The red oil pressure light, a hard brake pedal, a diesel-like noise and vibration; go to an authorised service centre without pushing the engine.

At how many km should the Peugeot 2008 timing belt be replaced?

Stellantis lowered the recommendation to 100,000 km / 6 years; the correct, clean fully synthetic oil preserves belt life.

Why does the oil pressure light come on in the Peugeot 2008?

It is usually caused by particles from the wet belt blocking the oil strainer; this is urgent — do not run the engine.

How can fuel dilution be recognised on the Peugeot 2008?

A rising oil level, oil that smells of fuel and a drop in viscosity are the signs; the correct fully synthetic oil + A980 reduces the risk.